Select the program data to be executed

2)Edit the SINK data among the program data.

SINK Setup [F1] → [Rotary key] or F2 or F3 to select item to be set

→Switch to check button ON Details of the items are listed below.

Item

Repeater	For using the VA-1809 as a repeater.

Receiver	For using the VA-1809 as a receiver (simple monitor).
DVI	For using the VA-1809 as a DVI monitor (repeater).

HDMI	For using the VA-1809 as an HDMI monitor (repeater).

HDCP ON	For using the VA-1809 as a monitor (repeater) that supports HDCP.
HDCP OFF	For using the VA-1809 as a monitor (repeater) that does not support
	HDCP.

*When using the VA-1809 as a receiver, no signals will be output from the HDMI connector or COAX OUT connector.

*When using the VA-1809 as DVI monitor (repeater), no sound can be input.

*If HDMI pictures using HDCP are input when HDCP is supported, they cannot be output from the VGA output connector.

*To save the program data on a card or as an internal pattern, move to SAVE MENU.

*To read the data saved, the execution mode must be set to PROGRAM MODE. Refer to page ???.

*When reading saved data, refer to page ???.

7.1.1.3Creating groups

The VA-1809 enables the data in up to ten program to be selected from among all the program data and executed.

Proceed as instructed in the steps below.

TOP → PROGRAMEXE[PROGRAM] → LISTEdit[F1]

(1) Select the numbers of the programs in the group to be executed.

[Rotary key] to select numbers of programs to be executed

[ENTER] to enter the selection

→

----------------------------選択画面表示-------------------------------------

(2) Select the program data to be executed.

[Rotary key] to select program data → [ENTER] to enter selection

----------------------------選択画面表示-------------------------------------