d.Release the WLAN antenna cables from the retention clips (4) and channels built into the top edge and right side of the display back cover.
e.Remove the WLAN antenna cables and transceivers.
The WLAN antenna cables and transceivers are included in the Antenna Kit, spare part number
Reverse this procedure to reassemble and install the display assembly.
Power connector cable
Description | Spare part number |
|
|
Power connector cable | |
|
|
Before removing the power connector cable, follow these steps:
1.Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.
2.Disconnect all external devices connected to the computer.
3.Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer.
4.Remove the keyboard/top cover (see Keyboard/top cover on page 30).
5.Disconnect the battery cable from the system board (see Battery on page 34).
6.Remove the display assembly (see Display assembly on page 42).
Remove the power connector cable:
1.Disconnect the power connector cable (1) from the system board.
48 Chapter 5 Removal and replacement procedures
