Hughes AN6-098P installation manual Small hardware parts lists, Part, Quantity, Comments

Small hardware parts lists

Tables 2 and 3 list the small hardware parts included in the antenna kits for the two radio types (J-type and cradle-type).

The parts listed in Table 2 are included in both kits, for both radio assembly types.

Table 2: Small hardware parts used in antenna kits for both radio types

Part	Quantity	Comments
For assembling the antenna
¼-20 × 1-3/8-inch thread-cutting screws	4	These parts are used for attaching the:
		• Reflector
¼-20 × 1-inch hex bolts	3
		• Feed rods
¼-20 × 2-inch hex bolt	1
		• Feed support tube
¼-inch flat washers	8	The hardware for each task is specified in Chapter 3
¼-inch lock washers	4
		– Assembling the antenna.
¼-inch hex nuts	4
For mounting the radio assembly (both types)
0.9-inch inside diameter O-ring *	1	These parts are used for both radio assemblies, to:
		• Attach the feed horn
No. 6-32 × 0.5-inch socket-head cap screws *	7
		• Mount the radio assembly
No. 6 internal tooth lock washers *	7
		The hardware for each task is specified in:
Silicone grease capsule	1
		• Chapter 4 – Installing a J-type radio assembly
5/16-18 × 2.25-inch carriage bolts	2
		• Chapter 5 – Installing a cradle-type radio
5/16-inch flat washers	4
		assembly
5/16-inch lock washers	4
5/16-inch hex nuts	2

* In the antenna kit for the J-type radio, the waveguide transition is attached to the feed horn at the factory, so these parts are factory installed.

18

Chapter 2 • Antenna parts and required tools 1037312-0001 Revision A