Installing the OPI To prepare for antenna pointing, attach the OPI to the receive cable from the LNB, as shown in Figure 46. Note that the OPI will not work unless it is enabled on the appropriate screen on the installation software. (Check the box labeled Enable OPI Display.) For further details, see Outdoor Pointing Interface Operating Instructions
HughesNet
LNB
Block
(if required)
OPI
T0172001
IDU
Figure 46: OPI
OPI block If you use an OPI with a model
Install the block between the OPI and the radio as illustrated in Figure 46. If the block you use has two female F connectors (at both ends), you will have to make a jumper cable to connect to the OPI.
58
Chapter 7 • Pointing the antenna