Hughes AN6-098P installation manual Tightening the hardware Tighten the hardware as follows

Tightening the hardware Tighten the hardware as follows:

1.Tighten the three nuts on the reflector rim (indicated by the black arrows in Figure 21).

2.Tighten the nut where the feed rods attach to the feed support tube (indicated by the white arrow in Figure 21).

Figure 21: Tightening nuts on feed rods and feed support tube

The antenna is now assembled, as shown in Figure 22, and ready for installation of the radio assembly.

•If you are installing a J-type radio, go to Chapter 4 – Installing a J-type radio assembly, on page 31.

•If you are installing a cradle-type radio, go to Chapter 5 – Installing a cradle-type radio assembly, on page 43.

Figure 22: Completed antenna assembly (without radio)

Chapter 3 • Assembling the antenna 1037312-0001 Revision A

29