7. Installation
Motor Setting
1.Select Motor Setting using the / button and press the OK or button.
2.Select Satellite using the / button and press the OK or button. Select the satellite the antenna is pointing to from the options using the / button and press the OK or button.
3.Select Transponder using the / button and press the OK or button. Select an option for transponder using the / button and press the OK or button. To add another transponder, select User Define from the list. Add transponder screen will appear. Enter the values for
Frequency, Polarization, Symbol Rate and FEC. Select Done and press the OK button to complete.
4.Select Driving Mode using the / button and press the OK or button to select an option. When motor driving is set as Step or Time, a pop up will appear to set the driving size. Select the driving size using the / button. Select OK and press the OK button.
Continuous | Motor moves continuously. |
|
|
Step | Motor moves by specified unit. |
|
|
Time | Motor moves during specified time. |
|
|
5.Select Go to Stored Position using the / button and press the / button to move the antenna to the position of the selected satellite. Wait till the antenna moves to the position of the satellite. Confirm signal strength and quality level and
6.Select Store Current Position using the / button and press the OK button to save the adjusted position of the satellite. The position of the antenna headed for the certain satellite will be saved.
Note: You can set the antenna position by repeating the procedure above.
7.Select Recalculate using the / button and press the OK button to recalculate the position of all satellites based on one satellite. Adjust the antenna position of a certain satellite. To readjust all positions, select OK and press the OK button.
Note: When Motor Kind is set as USALS, Driving Mode, Store Current Position, Recalculate is set to Disabled.
GB54
User’s Manual
