Video-Out and RS 232 Connectors

Your unit has a built-in Video Out connector and a dual RS 232 connector, which can be used with optional-purchase equipment such as AIS (Automatic Identification System). If you purchase a video monitor and attach it to your control head using the Video Out connector, your unit will send a video signal if it detects a monitor. See Setup Menu Tab: Video Out for more information.

1

2

3

4

5

6

1

RS 232

Temp/Speed

4

2

Video Output

Communications/GPS

5

3

Power

Transducer

6

NOTE: Accessories connected to the RS 232 or Video-Out connectors require a separate power source.

Installation Overview

Inside the boat there is often a channel or conduit used for other wiring, this can be used to route cables. Be sure to route the cable as far as practical from the antenna cable of VHF radios or tachometer cables to reduce the possibility of interference. The transducer and GPS receiver cables should not be cut, and care should be used not to damage the cable insulation.

Basic installation tasks that you must perform include:

•Installing the control head (choose gimbal or in-dash mounting, where in-dash mounting requires a separate purchase)

•Installing the transducer (choose the installation method that matches your transducer)

•Installing the GPS Receiver (if included)

•Testing the complete installation and locking the transducer position

NOTE: Accessories may require a separate purchase. You can visit our web site at humminbird.com to order these accessories online or contact our Customer Resource Center at 1-800-633-1468.

Control Head Installation

You have two choices for mounting your control head, Gimbal mounting, where you use a surface on the boat, such as the dash, to mount the control head so that it can be tilted up or down, or In-dash mounting, which requires a separate purchase.

Installation Introduction

6