Inserting the Pivot Bolt | Inserting the Pivot Arm Assembly into |
| the Mounting Bracket |
3.Put the pivot bolt through the assembly to hold it in position and loosely install the nut, but do NOT tighten the nut at this time. Insert the pivot arm assembly into the mounting bracket. Do NOT snap the assembly closed, as you will need to access the mounting bracket in the next step.
NOTE: If the pivot assembly is snapped closed over the mounting bracket, use a flat head screwdriver or similar tool to gently pry the assembly away from the mounting bracket.
4.Align the mounting bracket transducer assembly with the drilled holes in the transom. With a 5/16" socket driver, mount the assembly to the transom using the two #10 - 1" long screws provided.
Mounting the Assembly to the Transom | NOTE: Make sure that the mounting |
| screws are snug, but do not fully |
| tighten the mounting screws at this |
| time to allow the transducer |
| assembly to slide for adjustment |
| purposes. |
5. Snap the pivot arm down into place.
6. Adjust the initial angle of the transducer from back to front by rotating the transducer until the side seam on the transducer is almost parallel with the bottom of the boat, one click at a time in either direction.
Transom Mount - DualBeam PLUS™ | 18 |