Hunter Fan 41462-01 operation manual Hanging The Fan

®

STEP 4 - HANGING THE FAN

1.Disconnect the power by turn- ing off the circuit breakers to the outlet box and associated wall switch location.

2.Confirm that the three isolators are pre-installed on the hanger bracket. Refer to Figure 4a for location of the isolators.

Do not install the hanger bracket without the isolators installed.

Note: If the isolators are not pre-installed, place the three iso- lators on the hanger bracket as shown in Figure 4a.

3.Holding the hanger bracket with one hand and supporting the weight of the fan with the other hand, raise the hanger bracket up flush to the ceiling plate as shown in Figure 4b. Twist hanger bracket clockwise and lock in place.

Note: To remove the hanger bracket, while pressing the two small releases on the ceiling plate, twist the hanger bracket counterclockwise.

Hanger Bracket

Isolators

Figure 4a - Adding Isolators to the Hanger Bracket

Ceiling Plate

Hanger Bracket

Figure 4b - Hanging the Fan

41462-01 10/14/2005

11