®
STEP 9 - REMOTE CONTROL
REMOTE CRADLE INSTALLATION
STANDARD LIGHT SWITCH
1.Remove the two screws holding the switch cover plate. Do not re- move the cover plate.
2.Orient the control cradle as shown in Figure 9a, and line up the two inner mounting holes with those on the switch, insert screws, don't over tighten.
ROCKER LIGHT SWITCH
1.Break off the two tabs by push- ing outward. See Figure 9b.
2.Remove the two screws holding the switch cover plate. Do not re- move the cover plate.
3.Orient the remote cradle as shown in Figure 9b. Line up the two outer mounting holes with those on the switch , insert screws, don't over tighten.
WALL INSTALLATION
1.Locate a 2x4 wall stud in a conve- nient location.
2.Orienttheremotecradleasshown in Figure 9c, over the 2x4 stud.
3.Use the 1” wood screws in either theinneroroutermountingholes.
Note: Wall anchors and
Remove tabs
Figure 9a | Figure 9b | Figure 9c |
18