®
Do not turn the power off at the circuitbreaker,thenbackon,forthe previously installed fan(s), as you mayinadvertentlychangetheDIP switch code settingsforitaswell.
Note: The DIP SWITCH SETTING sub steps must be repeated as de- scribed above for the proper set- ting of the DIP switch code in the receiver and remote.
POWER FAILURE
The receiver has a memory function that retains the last DIP switch code setting. The setting will not change in the event of power failure or if powertothefanisinadvertentlyshut off.
FAN CONTROL
Refer to Figure 9f for identification of controlbuttons.
To start the fan press the selected speed button to run the fan at the desiredspeed.
To turn off the fan. Press the FAN OFF button.
Light
Fan Medium
Fan High
Fan Low
Fan Off
Reverse
Figure 9f - Control Buttons
AIRFLOW DIRECTION
To reverse the airflow press the RE- VERSE button. Reverse operates at any speed whether fan is on or off. The fan returns to its set speed after reversing.
If the fan is not functioning af- ter installation:
1.Check to make sure that battery is installed correctly in the con- trol.
2.Turn the power off to the fan (from the circuit breaker) for at least 5 seconds.
3.Turn the power back on (at the circuit breaker) and push the Hi, Med, and Low
4.The fan should now function properly.
20