Regulator: Controls the air pressure shown on the outlet pressure gauge. Turn knob clockwise to increase pressure and counterclockwise to decrease pressure.
Female Tire Chuck: Attaches to the hose end to be used to inflate tires. Note: To ensure correct tire pressure use a tire pressure gauge.
Blow Gun: Ideal for blowing, cleaning, and inflating. Depress lever on to release the air. Attaches to hose end.
Safety Nozzle: Prevents pressure
Inflating needles: Used to inflate sport balls. Requires blow gun adapter.
Tapered Inflator: Used to inflate toy inflatables/air mattresses. Brass tapered inflator attaches to blow gun outlet and plastic tapered inflator requires the blow gun adapter.
Rubber Tip Nozzle: Used to inflate
toy inflatables/air mattresses. Attaches to blow gun outlet.
High Flow Inflator/Deflator Adapter Body: Used with inflator/deflator nozzles it attaches directly to the universal valve adapter to inflate or deflate air mattresses, small boats, inflatable toys, and other inflatable items that use a large volume of low- pressure air. Requires blow gun adapter.
Inflator/Deflator Nozzles: Used with the high flow inflator/deflator adapter body.
Seal Ring: Used with inflator/deflator nozzles to prevent air from leaking out of inflatables with very large air inlets. Drain Valve (not shown): The drain valve is located at the base of the air tank and is used to drain condensation at the end of each use.
Cooling System (not shown): This compressor contains an advanced design cooling system. At the heart of this cooling system is an engineered fan. It is perfectly normal for this fan to blow air through the vent holes in large amounts. You know that the cooling system is working when air is being expelled.
Air Compressor Pump (not shown): Compresses air into the air tank. Working air is not available until the compressor has raised the air tank pressure above that required at the air outlet.
Check Valve (not shown): When the air compressor is operating, the check valve is "open", allowing compressed air to enter the air tank. When the air compressor reaches
How to Use Your Unit
How to Stop:
1.Set the
Before First Start-up
Risk of Unsafe Operation. Serious
damage may result if the following
This procedure is required before the air compressor is put into service.
1.Make sure the
2.Turn the regulator knob counterclockwise until it stops.
3.Plug the power cord into the correct branch circuit receptacle. (Refer to Voltage and Circuit Protection paragraph in the Installation section of this manual.)
13- ENG | A05051 |
