Husky A05051 manual Glossary, Accessories, Duty Cycle, Specification Chart, Assembly

GLOSSARY

Become familiar with these terms before operating the unit.

CFM: Cubic feet per minute.

SCFM: Standard cubic feet per minute; a unit of measure of air delivery.

PSIG: Pounds per square inch gauge; a unit of measure of pressure. Code Certification: Products that bear one or more of the following marks: UL, CUL, ETL, CETL, have been evaluated by OSHA certified independent safety laboratories and meet the applicable Underwriters Laboratories Standards for Safety. Cut-In Pressure: While the motor is off, air tank pressure drops as you continue to use your accessory.

When the tank pressure drops to a certain low level the motor will restart automatically. The low pressure at which the motor automatically restarts is called "cut-in" pressure. Cut-Out Pressure: When an air compressor is turned on and begins to run, air pressure in the air tank begins to build. It builds to a certain high pressure before the motor automatically shuts off, protecting your air tank from pressure higher than its capacity. The high pressure at which the motor shuts off is called "cut-out" pressure.

Branch Circuit: Circuit carrying electricity from electrical panel to outlet.

ACCESSORIES

Accessories for this unit are available at the store the unit was purchased.

DUTY CYCLE

This air compressor pump is capable of running continuously. However, to prolong the life of your air compressor, it is recommended that a 50%-75%

average duty cycle be maintained; that is, the air compressor pump should not run more than 30-45 minutes in any given hour.

SPECIFICATION CHART

Model No.	Y1010
Bore	1.875"
Stroke	1.25"
Voltage/Hertz/Phase	120V/60/1
Minimum Branch Circuit Requirement	15 amps
Fuse Type	Time Delay
Air Reserve (gallons)	1.75
SCFM @ 40 psig	3.0
SCFM @ 90 psig	2.0

ASSEMBLY

Contents of Carton

1 - Air Compressor

1 - Air Hose

1 - Blow Gun and Inflation Kit (7 pieces)

1- Inflator/Deflator Kit (7 pieces)

Tools Required for Assembly

1 - 9/16" open end wrench or adjustable wrench

1 - adjustable wrench

A05051 8- ENG