CONTROLLER SPECIFICATIONS AND REQUIREMENTS
The following illustration shows fan and vent locations on the front and back of the controller.
Figure 5-5. Sun Ultra 60 fan and vent locations to keep clear
1Vent in front of processor
2Fan in back of processor
3Vent in back of processor
Do not:
•
•
Do not place the controller monitor on top of the processor.
Do not allow any piece of equipment to blow warm air into the air intake vents of the processor.
•Do not place the processor on its side, or in any other position but the upright, vertical position shown in the previous figure.
•Do not place the processor or monitor on top of the printer.
XEROX DOCUPRINT NETWORK PRINTER SERIES INSTALLATION PLANNING GUIDE FOR MODELS 96/4635/180 NPS |
