CONTROLLER SPECIFICATIONS AND REQUIREMENTS
Space requirements
This section provides recommendations for placement of printer controller hardware components.
For printer component space requirements, refer to the “Printer specifications and requirements” chapter of this guide. Contact your service representative if you have questions not specifically addressed in this guide.
Printer controller placement
You should consider the following factors when deciding where to place the DocuPrint printer controller:
•Adequate work space and service clearance around the equipment
•
•
Proximity to electrical and network connectors
Security of the work area. You may need to place the system in an area where you can restrict access to it.
You must supply a table or desk as a work surface for the printer controller. The top of the table must provide at least 36 by 36 inches
/91.4 by 91.4 cm of space for each component, to allow enough space for the components and cables, as well as for service access.
Refer to the “Printer controller specifications and requirements” summary table at the end of this chapter to make sure the tables you supply can support the weight of the printer controller hardware elements, and that they are suitable for the intended use.
Warning: The printer controller must be positioned within the line-
!
Caution: Position the table at least 6 inches / 15.2 cm from the wall. Make sure the printer controller processor is at least 12 inches /
30.4 cm from the wall. Do not put the processor on the NPS printer. 
XEROX DOCUPRINT NETWORK PRINTER SERIES INSTALLATION PLANNING GUIDE FOR MODELS 96/4635/180 NPS |
