Husky A05051 manual Before Each Start-Up, How to Start

4.Open the drain valve fully (counterclockwise) to permit air to escape and prevent air pressure build up in the air tank during the break-in period.

5.Move the Off/Auto-On switch to "Auto-On" position. The compressor will start.

6.Run the compressor for 15 minutes. Make sure the drain valve is open and there is minimal air pressure build-up in tank.

7.After 15 minutes, close the drain valve (clockwise). The air receiver will fill to "cut-out" pressure and the motor will stop.

The compressor is now ready for use.

Before Each Start-Up:

1.Place Off/Auto-On switch to "Off" and close air regulator.

2.Turn the regulator knob counterclockwise until it stops.

3.Attach hose and accessories.

Risk of Bursting. Too much air

pressure causes a hazardous risk of bursting. Check the manufacturer’s maximum pressure rating for air tools and accessories. The regulator outlet pressure must never exceed the maximum pressure rating.

How to Start:

1.Turn the Off/Auto-On switch to "Auto-On" and allow tank pressure to build. Motor will stop when tank pressure reaches "cut-out" pressure.

2.Turn the regulator knob clockwise until desired pressure is reached. NOTE: To use the suggested pressure readings on the label, turn the regulator knob clockwise until the needle on the pressure gauge aligns with the desired suggested pressure reading number.

needle

3.The compressor is ready for use.

How to Use Telescopic Handle and Wheels for Easy Mobility

1.Press the release button and slide handle out until it locks into place.

2.Pull or push unit as shown. IMPORTANT: This handle is for pushing or pulling the unit. DO NOT lift the unit by this handle.

3.To lower handle, press the release button and push handle until it snaps into place for storage.

A05051 14- ENG