Husqvarna 11R Adjusting the parking brake Rider 13 C, Rider 16 C, Adjusting the throttle wire

Maintenance

Adjusting the parking brake Rider 13 C, Rider 16 C

Check that the brake is correctly adjusted by placing the machine on a slight downhill slope with the clutch disengaged and activating the brake.

When the machine does not stand still, the brake should be adjusted according to the following.

1Loosen the locking nuts (1).

2Tension the cable using the adjuster screw (2) until the play in the cable is taken up.

3Tighten the locking nuts (1).

4The brake should be checked again after adjustment

WARNING! A poorly adjusted brake can

!result in reduced braking ability.

Adjusting the parking brake Rider 16

AWD

Check that the parking brake is adjusted correctly by placing the machine on a slope with the front and rear axles disengaged. Apply and lock the parking brake. When the machine does not stand still, the parking brake should be adjusted according to the following.

1Remove the left-hand wing cover.

1Loosen the locking nuts (1).

2Tension the cable using the adjuster screw (2) until the play in the cable is taken up.

3Tighten the locking nuts (1).

4The brake should be checked again after adjustment

5 Assemble the left-hand wing cover.

WARNING! A poorly adjusted parking brake

!can result in reduced braking ability.

Adjusting the throttle wire

The throttle cable may need to be adjusted, if the engine does not respond as it should when accelerating, if it produces black smoke or maximum revs are not reached.

1Release the clamping screw that secures the wire casing and set the choke control to maximum choke.

2Pull the choke wire casing to the far right and tighten the clamping screw.

English – 23