Maintenance
Replacing the light bulbs
For information about the bulb type, see Technical Data.
1Loosen the lock nut and remove the Allen bolt. Remove the steering wheel.
2Unscrew the two screws holding the cover on the power servo housing. One screw on each side.
3Press in the parking lock button and lift the cover over the steering column.
4 Carefully remove the lamp insert from its two brackets.
5 Disconnect the cables from the bulbs.
6Lift out the bulbs from the insert.
7Insert the new bulbs. Make sure you use your thumb to support the front.
8Refit the cables, lamp insert and the cover on the power servo housing.
9 Replace the steering wheel.
Main fuse
The main fuse is placed in a detachable holder under the battery case’s cover, in front of the battery.
Type: Flat pin, 15 A.
Do not use any other type of fuse when replacing.
A blown fuse is indicated by a burnt connector. Pull the fuse from the holder when replacing.
The fuse is there to protect the electrical system. If it blows again shortly after replacement, it is due to a short circuit, which must be fixed before the machine can be put into operation again.
Checking the tyre pressure
The tyre pressure should be 60 kPa (0.6 bar / 9 PSI) all round. To improve driving the pressure on the rear tyres can be reduced to 40 kPa (0.4 bar/5.6 PSI). The maximum tyre pressure is 100 kPa (1,0 bar/14 PSI).
IMPORTANT INFORMATION
Different tyre pressures on the front tyres will result in the blades cutting the grass at different heights.
Checking the engine’s cooling air intake
Clean the air intake grille in the engine cover behind the driver’s seat.
24 – English
