Husqvarna 15T AWD, 15Ts AWD manual Service journal, Pre-deliveryservice, After the first 8 hours

Service journal

Pre-delivery service

1 Charge the battery for 4 hours at max. 3 amp.

2 Fit steering wheel, seat and any optional equipment.

3Check and adjust tyre pressure (60 Kpa, 0.6 bar, 9 PSI).

4Adjust cutting unit:

Adjust lift springs (effective weight of cutting unit should be 12-15kg / 26.5-33 lb).

Adjust cutting unit so that rear edge is about 2-4 mm / 1/8” higher than front edge.

Adjust the cutting unit’s cutting height setting so that the connection rod is tensed at the lowest cutting height.

5 Check that the right amount of oil is in the engine.

6 Check that there is oil in the transmission’s oil tank.

7 Connect battery.

8 Fill with fuel and start engine.

9Check that machine does not move in neutral.

10Check:

Forward drive.

Reverse drive.

Operation of blades.

Seat safety switch.

Lif lever safety switch.

The safety switch for the hydrostat pedals.

11 Check the engine speed See the Technical data section.

12Check the synchronisation between the front and rear wheels. (Only AWD-machines) See the workshop manual.

13Tell customer about:

Needs and benefits of following the service schedule.

Servicing and the influence of this journal on the second-hand value of the machine.

Range of applications for BioClip.

Complete proof of sale etc.

Pre-delivery service carried out. No outstanding problems. Certified:

___________________________________________________________________

Date, mileage, stamp, signature

After the first 8 hours

1 Change engine oil

2 Change the oil in the gearbox. (Only AWD-machines)

3 Check the synchronisation between the front and rear wheels. (Only AWD-machines)

English – 3