KEY to Symbols | Husqvarna 15Ts AWD, 15T AWD manual

KEY TO SYMBOLS

Symbols

These symbols are on the machine and in the instructions.

WARNING! Careless or incorrect use can result in serious or fatal injury to the operator or others.

Please read the operator’s manual carefully and make sure you understand the instructions before using the machine.

Always wear:

•Approved hearing protection

This product is in accordance with applicable EC directives.

Fast

Slow

Stop the engine.

Choke

Fuel

Oil level

Cutting height

Backwards

Forwards

Ignition

Hydrostatic freewheel

Parking brake

Noise emission to the environment according to the European Community’s Directive. The machine’s emission is speciﬁed in chapter Technical data and on label.

Clutch in

Clutch out

Warning: rotating parts. Keep hands and feet clear.

Rotary blades Keep hands and feet away from under the hood when the engine is running

Never drive across a slope

Never use the machine if persons, especially children, or animals, are in the vicinity

Never carry passengers on the machine or equipment

Drive very slowly if no cutting unit is ﬁtted

Brake

Starting instructions

Switch off the engine and

take off the ignition cable before repairs or maintenance

English – 5

Image 5

Husqvarna 15Ts AWD, 15T AWD manual KEY to Symbols

Contents

English Rider 15T Rider 15T AWD Rider 15Ts AWD Contents After the ﬁrst 8 hours Service journalPre-delivery service Introduction Symbols KEY to Symbols KEY to Symbols What is what on the ride-on mower What is WHAT? Safety instructions Safety InstructionsInsure your Rider General use This is what you do Driving on slopes Children Maintenance Transport Presentation Cutting unit Cutting height adjustment leverLifting lever for the cutting unit Lights Fuelling Exercise care and refuel outdoors see safety instructionsRelease lever Clutch control Rider 15T AWD and Rider 15Ts AWD Start the engine DrivingBefore starting Connecting the jump leads Starting the engine with a weak batteryDriving the Rider Remove the cables in the reverse order Stop the engine Cutting tips Maintenance schedule Maintenance Removing of the machine hoods CleaningChecking and adjusting the steering wires Can result in reduced braking ability Adjusting the parking brake Rider 15TChecking and adjusting of throttle wire Replacement of fuel ﬁlter Checking and adjusting the choke wireReplacing the air ﬁlter Cool before starting to replace the air ﬁlter Replacing the spark plug Checking the fuel pump’s air ﬁlterIgnition system Check the safety system Main fuse Replacing the light bulbsChecking the tyre pressure Checking the engine’s cooling air intake Fitting the cutting head When the engine is running. Mind your ﬁngersTrapping your hand Lift up the cutting unit Removing the cutting unit Hands when working with the blades Adjusting the parallelism of the cutting unitChecking the cutting unit’s parallelism Replacing the cutting unit belts Placing in the service position Service position for the cutting unit Checking the blades Restoring from service positionRemoving the BioClip plug CombiClip 103, CombiClip Checking the engine’s oil level LubricationChanging the oil ﬁlter Replacing the engine oil General lubrication Lubricating the belt adjusterChecking the transmission oil level Problem Procedure Troubleshooting schedule Storage ServiceWinter storage Guard Technical data Cutting unit CombiClip EN ISO 12100-2, EN-836 EC-declaration of conformity Applies to Europe onlyEC-declaration of conformity Page ´z+U+r¶6§¨ Page 1153118-26 ´z+U+r¶6§¨ ´z+U+r¶6§¨