What is WHAT?

What is what on the ride-on mower

1	Choke control	10	Parking brake
2	Switch for the lights	11	Lock button for parking brake
3	Throttle control	12	Seat adjustment.
4	Ignition lock	13	Product and serial number plate
5	Counter	14	Lever to disengage the driving front axle: 15T AWD, 15Ts
6	Cutting height adjustment lever		AWD
6	Cutting height adjustment lever
7	Lifting lever for the cutting unit	15	Fuel cap
7	Lifting lever for the cutting unit
8	Speed limiter for reversing	16	Cover lock
8	Speed limiter for reversing
9	Speed limiter for driving forward	17	Lever to disengage the drive Rider 15T
9	Speed limiter for driving forward		Lever to disengage the driving rear axle, 15T AWD, 15Ts
			Lever to disengage the driving rear axle, 15T AWD, 15Ts

AWD

English – 7

Page 7

Image 7

Husqvarna 15T AWD, 15Ts AWD manual What is WHAT?, What is what on the ride-on mower

Contents

English Rider 15T Rider 15T AWD Rider 15Ts AWD Contents Pre-delivery service Service journalAfter the ﬁrst 8 hours Introduction Symbols KEY to Symbols KEY to Symbols What is what on the ride-on mower What is WHAT? General use Safety InstructionsSafety instructions Insure your Rider This is what you do Driving on slopes Children Maintenance Transport Presentation Lights Cutting height adjustment leverCutting unit Lifting lever for the cutting unit Clutch control Rider 15T AWD and Rider 15Ts AWD Exercise care and refuel outdoors see safety instructionsFuelling Release lever Before starting DrivingStart the engine Remove the cables in the reverse order Starting the engine with a weak batteryConnecting the jump leads Driving the Rider Stop the engine Cutting tips Maintenance schedule Maintenance Checking and adjusting the steering wires CleaningRemoving of the machine hoods Checking and adjusting of throttle wire Adjusting the parking brake Rider 15TCan result in reduced braking ability Cool before starting to replace the air ﬁlter Checking and adjusting the choke wireReplacement of fuel ﬁlter Replacing the air ﬁlter Ignition system Checking the fuel pump’s air ﬁlterReplacing the spark plug Check the safety system Checking the engine’s cooling air intake Replacing the light bulbsMain fuse Checking the tyre pressure Lift up the cutting unit When the engine is running. Mind your ﬁngersFitting the cutting head Trapping your hand Removing the cutting unit Replacing the cutting unit belts Adjusting the parallelism of the cutting unitHands when working with the blades Checking the cutting unit’s parallelism Placing in the service position Service position for the cutting unit CombiClip 103, CombiClip Restoring from service positionChecking the blades Removing the BioClip plug Replacing the engine oil LubricationChecking the engine’s oil level Changing the oil ﬁlter Checking the transmission oil level Lubricating the belt adjusterGeneral lubrication Problem Procedure Troubleshooting schedule Guard ServiceStorage Winter storage Technical data Cutting unit CombiClip EC-declaration of conformity EC-declaration of conformity Applies to Europe onlyEN ISO 12100-2, EN-836 Page ´z+U+r¶6§¨ Page 1153118-26 ´z+U+r¶6§¨ ´z+U+r¶6§¨