Cutting unit CombiClip | Husqvarna 15Ts AWD, 15T AWD manual

Technical data

Cutting unit	CombiClip 94	CombiClip 103	CombiClip 112
Cutting width, mm/inch	940/37	1030 / 41	1120	/ 44.1
Cutting heights, 7 positions, mm/inch	25-75/0.98-2.95	25-75/0.98-2.95	25-75/0.98-2.95
Blade length, mm/inch	358/14.09	388/15.28	420 /	16,5

IMPORTANT INFORMATION When the service life of this product has been served and it is no longer used it should be returned to the dealer or to an applicable station for recycling.

IMPORTANT INFORMATION We reserve the right to change speciﬁcations and designs without prior notice so as to implement improvements.

Note that no legal claims are valid on the basis of information in this manual.

Use only genuine parts for repairs. The warranty is not valid if non genuine parts are used.

English – 35

Page 35

Image 35

Husqvarna 15Ts AWD, 15T AWD manual Cutting unit CombiClip

Contents

English Rider 15T Rider 15T AWD Rider 15Ts AWD Contents After the ﬁrst 8 hours Service journalPre-delivery service Introduction Symbols KEY to Symbols KEY to Symbols What is what on the ride-on mower What is WHAT? General use Safety InstructionsSafety instructions Insure your Rider This is what you do Driving on slopes Children Maintenance Transport Presentation Lights Cutting height adjustment leverCutting unit Lifting lever for the cutting unit Clutch control Rider 15T AWD and Rider 15Ts AWD Exercise care and refuel outdoors see safety instructionsFuelling Release lever Start the engine DrivingBefore starting Remove the cables in the reverse order Starting the engine with a weak batteryConnecting the jump leads Driving the Rider Stop the engine Cutting tips Maintenance schedule Maintenance Removing of the machine hoods CleaningChecking and adjusting the steering wires Can result in reduced braking ability Adjusting the parking brake Rider 15TChecking and adjusting of throttle wire Cool before starting to replace the air ﬁlter Checking and adjusting the choke wireReplacement of fuel ﬁlter Replacing the air ﬁlter Replacing the spark plug Checking the fuel pump’s air ﬁlterIgnition system Check the safety system Checking the engine’s cooling air intake Replacing the light bulbsMain fuse Checking the tyre pressure Lift up the cutting unit When the engine is running. Mind your ﬁngersFitting the cutting head Trapping your hand Removing the cutting unit Replacing the cutting unit belts Adjusting the parallelism of the cutting unitHands when working with the blades Checking the cutting unit’s parallelism Placing in the service position Service position for the cutting unit CombiClip 103, CombiClip Restoring from service positionChecking the blades Removing the BioClip plug Replacing the engine oil LubricationChecking the engine’s oil level Changing the oil ﬁlter General lubrication Lubricating the belt adjusterChecking the transmission oil level Problem Procedure Troubleshooting schedule Guard ServiceStorage Winter storage Technical data Cutting unit CombiClip EN ISO 12100-2, EN-836 EC-declaration of conformity Applies to Europe onlyEC-declaration of conformity Page ´z+U+r¶6§¨ Page 1153118-26 ´z+U+r¶6§¨ ´z+U+r¶6§¨

Technical data

Cutting unit

CombiClip 94