Driving, Before starting, Start the engine | Husqvarna 15T AWD

Driving

Before starting

•Read the safety instructions and information concerning the placement of controls and functions before starting.

•Perform daily maintenance before starting as set out in the Maintenance schedule.

IMPORTANT INFORMATION

The air intake grille in the engine cover behind the driver’s seat must not be blocked by, for example, clothing, leaves, grass or dirt. Impaired cooling of the engine.

Risk of major engine damage.

Start the engine

1Make sure that the clutch control is depressed. Rider 15T AWD and Rider 15Ts AWD have one control for the front axle and one control for the rear axle.

2Lift up the cutting unit by pulling the lever backwards to locked position (transport position) and apply the parking brake. The engine can not be started if the parking brake is not pressed down.

3 Move the throttle control to the middle position.

4If the engine is cold move the choke lever backwards to its end position.

5 Turn the ignition key to the start position.

6When the engine starts release the ignition key immediately back to neutral position.

IMPORTANT INFORMATION

Do not run the starter for more than about 5 seconds at a time. If the engine does not start, wait about 15 seconds before trying again.

7Push the choke lever gradually forward when the engine has started.

English – 15

Image 15

Husqvarna 15T AWD, 15Ts AWD manual Driving, Before starting, Start the engine

Contents

English Rider 15T Rider 15T AWD Rider 15Ts AWD Contents Service journal Pre-delivery serviceAfter the ﬁrst 8 hours Introduction Symbols KEY to Symbols KEY to Symbols What is what on the ride-on mower What is WHAT? General use Safety InstructionsSafety instructions Insure your Rider This is what you do Driving on slopes Children Maintenance Transport Presentation Lights Cutting height adjustment leverCutting unit Lifting lever for the cutting unit Clutch control Rider 15T AWD and Rider 15Ts AWD Exercise care and refuel outdoors see safety instructionsFuelling Release lever Driving Before startingStart the engine Remove the cables in the reverse order Starting the engine with a weak batteryConnecting the jump leads Driving the Rider Stop the engine Cutting tips Maintenance schedule Maintenance Cleaning Checking and adjusting the steering wiresRemoving of the machine hoods Adjusting the parking brake Rider 15T Checking and adjusting of throttle wireCan result in reduced braking ability Cool before starting to replace the air ﬁlter Checking and adjusting the choke wireReplacement of fuel ﬁlter Replacing the air ﬁlter Checking the fuel pump’s air ﬁlter Ignition systemReplacing the spark plug Check the safety system Checking the engine’s cooling air intake Replacing the light bulbsMain fuse Checking the tyre pressure Lift up the cutting unit When the engine is running. Mind your ﬁngersFitting the cutting head Trapping your hand Removing the cutting unit Replacing the cutting unit belts Adjusting the parallelism of the cutting unitHands when working with the blades Checking the cutting unit’s parallelism Placing in the service position Service position for the cutting unit CombiClip 103, CombiClip Restoring from service positionChecking the blades Removing the BioClip plug Replacing the engine oil LubricationChecking the engine’s oil level Changing the oil ﬁlter Lubricating the belt adjuster Checking the transmission oil levelGeneral lubrication Problem Procedure Troubleshooting schedule Guard ServiceStorage Winter storage Technical data Cutting unit CombiClip EC-declaration of conformity Applies to Europe only EC-declaration of conformityEN ISO 12100-2, EN-836 Page ´z+U+r¶6§¨ Page 1153118-26 ´z+U+r¶6§¨ ´z+U+r¶6§¨