3. INSTALLATION
•Make sure to lay the boundary wire tight to the ground and secure the staples close together with approximately 75 cm between each staple. The wire must generally lie close to the ground so, as not to be cut off before the grass roots have grown over it.
•Use a hammer to knock down the staples in the ground. Exercise care when knocking in the staples and make sure the wire is not under strain. Avoid forming the wire in sharp bends.
If you intend to bury the boundary wire:
•Make sure to place the boundary wire at least
1 cm and a maximum of 20 cm into the ground.
The boundary wire must be crossed on the path to and from an island.
|
Laying the boundary wire in towards the loop generator/charger
The ends of the boundary wire are run in parallel and close to each other in towards the loop generator/charger. As long as the total length of the boundary wire does not exceed 250 m, the sections where the wires run in parallel can be any length. For example, it is possible to place the loop generator/charger inside the house and run the boundary wire through a window and out to the garden.
24 - English
