8. TROUBLE SHOOTING
8. Trouble shooting
8.1 Fault messages
A number of fault messages that can be shown by the red Fault indicator lamp on Husqvarna Automower™ are shown below. The fault message is interpreted by reading how the lamp flashes. The lamp flashes one to five times in quick succession and then goes out for 2 seconds. This sequence is repeated until the Cancel button is pressed. For example, three flashes in the table below corresponds to the lamp flashing three times in quick succession, and then going out.
Always try to restart the mower if the Fault indicator lamp is lit or flashes. Restart the mower by pressing the Cancel button, enter your PIN code and close the cover
If the same fault occurs frequently, or if the Fault indicator lamp is lit with a steady light: contact your dealer.
Flashes | Fault message | Cause | Action |
|
|
|
|
|
|
|
|
1 | Wrong PIN code | Wrong PIN code has been | Enter the correct PIN code. |
|
| entered. Three attempts are |
|
|
| permitted, the keypad is then |
|
|
| blocked for five minutes. |
|
|
|
|
|
1 | Charger cable not | The charger cable is not | Connect the charger cable |
| connected | connected when changing the |
|
|
| PIN code, or when connecting |
|
|
| the mower to the loop |
|
|
| generator/charger. |
|
|
|
|
|
2 | No loop signal | The loop generator/charger is | Check the wall socket connection and |
|
| not connected to the mains | whether the miniature |
|
| supply or its miniature | tripped. |
|
| Reset the miniature | |
|
|
| removing the loop generator/charger's power |
|
|
| cord from the wall socket, wait 10 seconds |
|
|
| and then reconnect the power cord in the |
|
|
| wall socket again. |
|
|
|
|
|
| Boundary wire broken. | Check the signal given by the LED on the |
|
|
| loop generator/charger. If it flashes the loop |
|
|
| is damaged. Repair the broken cable using |
|
|
| an original waterproof coupler. |
|
|
|
|
|
| The connection between | Link the mower to the loop |
|
| Automower and the charging | generator/charger by changing the PIN |
|
| station has been lost. | code, see page 30. You can use the same |
|
|
| PIN code as earlier. You can use the same |
|
|
| PIN code as earlier. |
|
|
|
|
|
| This may be due to the | Check that the boundary wire has been |
|
| boundary wire being routed in | routed correctly. |
|
| the wrong direction around an |
|
|
| ”island”, which blanks out the |
|
|
| signal. |
|
|
|
|
|
|
| If this occurs in isolated areas | Try moving the boundary wire. |
|
| it may be due to interference |
|
|
| from metallic objects |
|
|
| (perimeter fence, |
|
|
| reinforcement bar) or buried |
|
|
| cables in the vicinity. |
|
|
|
|
|
3 | No drive | Automower has got caught in | Free the mower and rectify the reason for |
|
| something. | the lack of drive. If it is due to wet grass, wait |
|
|
| until the lawn has dried before using the |
|
|
| mower. |
|
|
|
|
English - 41
