Husqvarna 343F, 345FX, 345FXT, 343R, 345RX manual Dismantling, 502 54

Electrical system 2

Dismantling

Remove the starter, cylinder cover, and spark plug.

Attach piston stop no. 502 54 15-01.

502 54 15-01

Remove the nut holding the flywheel.

Remove the flywheel.

502 51 94-01

Remove the ignition module and the generator.

502 50 18-01

Dismantling

Remove the starter, cylinder cover, and spark plug.

Fit piston stop no. 502 54 15-01 in the spark plug hole.

NOTE!

Place the piston stop so it is caught between the piston and the cylinder head. Not so it sticks out into the exhaust port.

Remove the nut holding the flywheel.

Remove the flywheel from the crank- shaft using punch no. 502 51 94-01.

Leave a gap of approx. 2 mm between the punch and the flywheel.

Gently knock the punch with a hammer while holding the flywheel with your other hand.

Dismantle the ignition module.

Remove the ignition cable from the holder (A).

Remove both bolts (B).

Loosen the short-circuit cable (C) from the ignition module.

Remove the generator (D) that supplies power to the heated handles.

11