Fuel system | 3 |
Assembling the carburettor
Blow the carburettor housing clean.
Fit a new plug.
Fit a new main jet.
Assembling the carburettor
•Blow all channels in the carburettor compartment clean
•Mount a new plug.
Use a suitable punch to get a completely tight seal.
•Press in a new main jet.
•Mount the valves and dampers.
Tip!
Any numbers on the valves should be able to be read from the outside.
Replace the fuel screen if it is damaged or cannot be cleaned.
Place the pump diaphragm closest to the carburettor housing. Then the gasket and cover and the other compo- nents in reverse order of removal.
NOTE!
Check that the valves are turned correctly and that they close completely and tightly in the closed position.
Use Loctite on the valve screws.
23
