5

Angle gear

 

 

Shaft

Shaft

 

The shaft contains a drive axle guide

The shaft contains a long plastic guide

 

that is easily replaced. It can be

to prevent vibrations in the drive axle.

 

dismantled once the plastic sleeve (B)

The guide (A) is easily removed for

 

has been removed.

 

replacement.

 

 

 

Centre the axle control in the shaft

Bend away the plastic sleeve (B) and

 

when a new one is fitted.

 

the O-ring (C) using a knife and pull the

 

 

 

Fit a new O-ring to ensure a good seal.

drive axle guide out from the shaft.

 

 

When replacing the axle guide, the

 

 

replacement must be inserted into the

 

 

shaft so that the distance is the same to

 

 

the two ends of the shaft.

 

 

When fitting, a new O-ring must be

 

503 80 17-01

used. To avoid damage from the sharp

 

edges of the slits in the gearbox, the

 

 

 

 

following assembly procedure is

 

 

recommended:

 

 

1. Place the plastic sleeve (B) in

 

 

position in the gearbox.

 

 

2. Slide the O-ring (C) onto the plastic

 

 

sleeve.

 

 

3. Slide the shaft and guide (A) into

 

 

position.

 

 

Lubricate the drive axle with grease no.

 

 

503 80 17-01 when assembling.

40

Page 41
Image 41
Husqvarna 343F, 345FX, 345FXT, 343R, 345RX manual Shaft, 503 80