5

Angle gear

The angle gear has two purposes:

The first is to gear down the engine’s high speed to better suit the lower speed a saw blade or trimmer requires to work efficiently.

Second, the angle gear contributes to the saw opera- tor’s working stance so that it is comfortable and at the same time efficient. The power from the engine, via the drive axle, shall in other words be angled so that the cutting equipment works parallel to the ground.

Dismantling

Remove the cutting equipment and guard.

Then loosen the bolts holding the angle gear against the shaft.

Remove the angle gear from the shaft.

Remove the circlip and washer on the output axle.

Dismantling

First remove the cutting equipment (saw blade, trimmer etc.) and guard.

Then loosen the bolts holding the angle gear against the shaft.

Remove the angle gear from the shaft.

Use a screwdriver if necessary to separate the mechanical joint.

Remove the circlip on the output axle using circlip pliers.

Lift off the washer from the sealing ring.

Remove the large circlip from the input axle.

Remove the large circlip from the input axle.

NOTE!

Let the small circlip around the axle remain.

38

Page 39
Image 39
Husqvarna 343F, 345FX, 345FXT, 343R, 345RX manual Angle gear, Let the small circlip around the axle remain