101
Rider 11/13 Rider 11 Bio/13 Bio
Operator´s manual
CONTENTS Operator’s Manual for Rider 11 and Rider
Rider 11 Bio and Rider 13 Bio
IMPORTANT INFORMATION
Travel and transport on public roads
INSTRUCTION
Dear customer
Towing
Serial number
SAFETY INSTRUCTIONS
Good service
Engine
EXPLANATION OF SYMBOLS
Clear the area from stones etc. before cutting
General use
Read the instructions before starting the machine
Never carry passengers
Do as follows
Be extra careful when driving on slopes
Driving on slopes
Cut slopes upwards and downwards, not sideways
Keep children away from the mowing area
Maintenance
Children
Never allow children to drive the machine
battery can explode and cause severe injuries
Clean the machine regularly from grass, leaves and other waste
SAFETY INSTRUCTIONS
Avoid overfilling. If fuel has been spilt on the
PRESENTATION
Presentation
Location of the controls
Clutch pedal
PRESENTATION RIDER 11 / 11 BIO
Throttle and Choke lever
Brake pedal / Parking brake
Parking brake
PRESENTATION RIDER 13/13 BIO
Speed limiter
Throttle and Choke lever
Rider 11 Bio and Rider 13 Bio have a twin-blade
Cutting unit
Lift lever for cutting unit
Lifting of the cutting unit transport position
Fuelling
Lever for adjustment of cutting height
Seat
Rider
Starting the engine
DRIVING
Before starting
Rider
DRIVING
Cold engine
Warm engine
5. Set the throttle control midway between position 1 and
For Rider 11 and Rider 11 Bio
Driving the machine
2. For Rider 13 and Rider 13 Bio
The clutch must be used for each gear change
DRIVING
Cutting tips
Mowing pattern
IMPORTANT INFORMATION
Release lever Rider 13 and Rider 13 Bio
Hill start, manual gearbox
Stopping the engine
DRIVING
Maintenance interval
MAINTENANCE
Maintenance schedule
Maintenance
Front hood Rider 11 and Rider
Dismantling of the machine hoods
Engine hood
Front hood Rider 11 Bio and Rider 13 Bio
MAINTENANCE
Right-hand fender
Left-hand fender
Release the screws in the fender and lift off the fender
Checking and adjustment of the steering wires
MAINTENANCE
Poorly adjusted brakes can result in reduced braking power
Adjusting the brake Rider 11 and Rider 11 Bio
Check and adjust the brakes on Rider 13 and Rider 13 Bio
Checking the brake Rider 11 and Rider 11 Bio
Checking and adjustment of the throttle wire
Replacement of the fuel filter
MAINTENANCE
MAINTENANCE
Do not use compressed air to clean the paper filter
Replacing the air filter
IMPORTANT INFORMATION
Checking of the fuel pump’s air filter
Check the level of the battery acid
Procedures on contact with acid
MAINTENANCE
Inspecting the safety system
Rider Rider
MAINTENANCE
MAINTENANCE
Checking the tyre pressure
Check the engine’s cooling air intake
IMPORTANT INFORMATION
Checking the cutting unit’s parallelism
MAINTENANCE
MAINTENANCE
30 - English
MAINTENANCE RIDER 11 BIO/13 BIO
Service position for BioClip
Placing in service position
MAINTENANCE RIDER 11 BIO/13 BIO
5. Disengage the spring from the drive belt tensioning wheel
Restoring from service position
MAINTENANCE RIDER 11 BIO/13 BIO
Cutting unit rear ejection Bio
Checking the blades
Replacing the break-pin BioClip
MAINTENANCE
Changing the oil
LUBRICATION
Check the engine’s oil level
IMPORTANT INFORMATION
General lubrication
Check the transmission’s oil level Rider 13 and Rider 13 Bio
Lubrication of belt tensioner
LUBRICATION
Check that the lock-ring is correctly posi- tioned in the slot
Lubrication Rider 11 and Rider 11 Bio
Lubrication of front wheel bearings
LUBRICATION
TROUBLE SHOOTING SCHEDULE
Problem
Procedure
Service
STORAGE
Winter storage
Rider
TECHNICAL DATA
Dimensions
Electrical system
TECHNICAL DATA
Rider 11 Bio
Rider 13 Bio
Dimensions
EU declaration of conformity Only applies to Europe
Directive 89/392/EEC, Annex II, A
Work done
SERVICEJOURNAL RIDER 11/13
Pre-delivery service
Date, mileage, stamp, sign
Work done
SERVICEJOURNAL
´*3/r¶69¨
Date, mileage, stamp, sign
Page
2000W50
´*3/r¶69¨