Husqvarna 39765, 13 Bio, 11 Bio manual SERVICEJOURNAL RIDER 11/13, Pre-delivery service, Work done

	SERVICEJOURNAL RIDER 11/13
Work done		Date, mileage, stamp, sign
Pre-delivery service
1.	Top up battery with acid and recharge for four hours.
2.	Fit steering wheel, seat and any optional equipment.
3.	Adjust cutting unit:
	Adjust the lifting springs (the “weight” of the cutting unit should
	be 12-15 kg). Only applies to BioClip.
	Adjust cutting unit so that rear edge is about 2–4 mm higher
	than front edge.
	Adjust cutting unit height setting so that cutting height limit is 5
	mm above the frame of the unit at the lowest cutting height.
4.	Check that engine has correct amount of oil.

5.Check that the right amount of oil is in the transmission. (Not Rider 11)

6. Check and adjust tyre pressure (60 kPa, 0.6 bar).
7. Connect battery.
8. Fill with fuel and start engine.
9. Check that machine does not move in neutral. (Not Rider 11)
10. Check:
Forward drive.
Reverse drive.
Operation of blades.
Seat safety switch.
Lift lever safety switch.
Safety switch for hydrostatic pedals/neutral setting.
11. Check engine revs 2 950 rpm.
12. Tell customer about:	Pre-delivery service carried out.
Need and benefits of following the service schedule.	No outstanding problems.
The need and advantages of leaving the machine for regular	Certified:
service.
The effects of maintenance on the machine’s second hand
value.
Range of applications for BioClip.
13. Complete proof of sale, etc.

After first 5 hours 1. Change engine oil.

English – 43