Operator´s manual
101
Rider 11/13 Rider 11 Bio/13 Bio
IMPORTANT INFORMATION
CONTENTS Operator’s Manual for Rider 11 and Rider
Rider 11 Bio and Rider 13 Bio
Towing
INSTRUCTION
Dear customer
Travel and transport on public roads
Engine
SAFETY INSTRUCTIONS
Good service
Serial number
EXPLANATION OF SYMBOLS
Never carry passengers
General use
Read the instructions before starting the machine
Clear the area from stones etc. before cutting
Cut slopes upwards and downwards, not sideways
Be extra careful when driving on slopes
Driving on slopes
Do as follows
Never allow children to drive the machine
Maintenance
Children
Keep children away from the mowing area
Avoid overfilling. If fuel has been spilt on the
Clean the machine regularly from grass, leaves and other waste
SAFETY INSTRUCTIONS
battery can explode and cause severe injuries
Location of the controls
PRESENTATION
Presentation
Brake pedal / Parking brake
PRESENTATION RIDER 11 / 11 BIO
Throttle and Choke lever
Clutch pedal
Throttle and Choke lever
PRESENTATION RIDER 13/13 BIO
Speed limiter
Parking brake
Lifting of the cutting unit transport position
Cutting unit
Lift lever for cutting unit
Rider 11 Bio and Rider 13 Bio have a twin-blade
Rider
Lever for adjustment of cutting height
Seat
Fuelling
Rider
DRIVING
Before starting
Starting the engine
5. Set the throttle control midway between position 1 and
Cold engine
Warm engine
DRIVING
The clutch must be used for each gear change
Driving the machine
2. For Rider 13 and Rider 13 Bio
For Rider 11 and Rider 11 Bio
IMPORTANT INFORMATION
Cutting tips
Mowing pattern
DRIVING
DRIVING
Hill start, manual gearbox
Stopping the engine
Release lever Rider 13 and Rider 13 Bio
Maintenance
MAINTENANCE
Maintenance schedule
Maintenance interval
Front hood Rider 11 Bio and Rider 13 Bio
Dismantling of the machine hoods
Engine hood
Front hood Rider 11 and Rider
Release the screws in the fender and lift off the fender
Right-hand fender
Left-hand fender
MAINTENANCE
MAINTENANCE
Checking and adjustment of the steering wires
Checking the brake Rider 11 and Rider 11 Bio
Adjusting the brake Rider 11 and Rider 11 Bio
Check and adjust the brakes on Rider 13 and Rider 13 Bio
Poorly adjusted brakes can result in reduced braking power
MAINTENANCE
Checking and adjustment of the throttle wire
Replacement of the fuel filter
IMPORTANT INFORMATION
Do not use compressed air to clean the paper filter
Replacing the air filter
MAINTENANCE
MAINTENANCE
Check the level of the battery acid
Procedures on contact with acid
Checking of the fuel pump’s air filter
MAINTENANCE
Inspecting the safety system
Rider Rider
IMPORTANT INFORMATION
Checking the tyre pressure
Check the engine’s cooling air intake
MAINTENANCE
MAINTENANCE
Checking the cutting unit’s parallelism
30 - English
MAINTENANCE
Placing in service position
MAINTENANCE RIDER 11 BIO/13 BIO
Service position for BioClip
5. Disengage the spring from the drive belt tensioning wheel
MAINTENANCE RIDER 11 BIO/13 BIO
MAINTENANCE RIDER 11 BIO/13 BIO
Restoring from service position
MAINTENANCE
Checking the blades
Replacing the break-pin BioClip
Cutting unit rear ejection Bio
IMPORTANT INFORMATION
LUBRICATION
Check the engine’s oil level
Changing the oil
LUBRICATION
Check the transmission’s oil level Rider 13 and Rider 13 Bio
Lubrication of belt tensioner
General lubrication
LUBRICATION
Lubrication Rider 11 and Rider 11 Bio
Lubrication of front wheel bearings
Check that the lock-ring is correctly posi- tioned in the slot
Procedure
TROUBLE SHOOTING SCHEDULE
Problem
Winter storage
Service
STORAGE
Electrical system
TECHNICAL DATA
Dimensions
Rider
Dimensions
Rider 11 Bio
Rider 13 Bio
TECHNICAL DATA
Directive 89/392/EEC, Annex II, A
EU declaration of conformity Only applies to Europe
Date, mileage, stamp, sign
SERVICEJOURNAL RIDER 11/13
Pre-delivery service
Work done
Date, mileage, stamp, sign
SERVICEJOURNAL
´*3/r¶69¨
Work done
Page
´*3/r¶69¨
2000W50