Right-hand fender, Left-hand fender | Husqvarna 11, 39765, 13 Bio

MAINTENANCE

Right-hand fender

Remove the screws (2 and 3) from the fender. On the Rider 13 and Rider 13 Bio the knob (1) must also be removed.

Left-hand fender

Release the screws in the fender and lift off the fender.

	3
11	2
11

English – 21

Image 22

Husqvarna 39765, 13 Bio, 11 Bio manual Right-hand fender, Left-hand fender

Contents

Rider 11/13 Rider 11 Bio/13 Bio 101 91 Contents Travel and transport on public roads InstructionDear customer Towing Serial number Safety InstructionsGood service Engine Transmission Explanation of Symbols These instructions are for your safety. Read them carefully General use Driving on slopes Do as follows Maintenance Children Battery can explode and cause severe injuries Presentation PresentationLocation of the controls Clutch pedal Presentation Rider 11 / 11 BIOThrottle and Choke lever Brake pedal / Parking brake Speed limiter Presentation Rider 13/13 BIOParking brake Lift lever for cutting unit Cutting unitRider 11 Bio and Rider 13 Bio have a twin-blade Seat Lever for adjustment of cutting heightFuelling Before starting DrivingStarting the engine Cold engine Warm engine For Rider 13 and Rider 13 Bio Driving the machineFor Rider 11 and Rider 11 Bio Cutting tips Stopping the engine Hill start, manual gearboxRelease lever Rider 13 and Rider 13 Bio Maintenance schedule MaintenanceDaily Maintenance interval Hours Nance 100 Front hood Rider 11 and Rider Dismantling of the machine hoodsEngine hood Front hood Rider 11 Bio and Rider 13 Bio Right-hand fender Left-hand fender Checking and adjustment of the steering wires Poorly adjusted brakes can result in reduced braking power Adjusting the brake Rider 11 and Rider 11 BioCheck and adjust the brakes on Rider 13 and Rider 13 Bio Checking the brake Rider 11 and Rider 11 Bio Checking and adjustment of the throttle wire Replacement of the fuel filter Do not use compressed air to clean the paper filter Replacing the air filter Procedures on contact with acid Check the level of the battery acidChecking of the fuel pump’s air filter Inspecting the safety system Checking the tyre pressure Check the engine’s cooling air intake Checking the cutting unit’s parallelism Maintenance Service position for BioClip Maintenance Rider 11 BIO/13 BIOPlacing in service position Maintenance Rider 11 BIO/13 BIO Restoring from service position Checking the blades Replacing the break-pin BioClip Check the engine’s oil level LubricationChanging the oil Lubrication of belt tensioner General lubrication Lubrication Rider 11 and Rider 11 Bio Lubrication of front wheel bearings Trouble Shooting Schedule Problem Procedure Storage ServiceWinter storage Engine Technical DataDimensions Rider Electrical system Dimensions Rider 11 Bio Rider 13 Bio EU declaration of conformity Only applies to Europe Pre-delivery service Servicejournal Rider 11/13Work done Date, mileage, stamp, sign Servicejournal Page 2000W50