Operator´s manual
101
Rider 11/13 Rider 11 Bio/13 Bio
IMPORTANT INFORMATION
CONTENTS Operator’s Manual for Rider 11 and Rider
Rider 11 Bio and Rider 13 Bio
Dear customer
INSTRUCTION
Travel and transport on public roads
Towing
Good service
SAFETY INSTRUCTIONS
Serial number
Engine
EXPLANATION OF SYMBOLS
Read the instructions before starting the machine
General use
Clear the area from stones etc. before cutting
Never carry passengers
Driving on slopes
Be extra careful when driving on slopes
Do as follows
Cut slopes upwards and downwards, not sideways
Children
Maintenance
Keep children away from the mowing area
Never allow children to drive the machine
SAFETY INSTRUCTIONS
Clean the machine regularly from grass, leaves and other waste
battery can explode and cause severe injuries
Avoid overfilling. If fuel has been spilt on the
Location of the controls
PRESENTATION
Presentation
Throttle and Choke lever
PRESENTATION RIDER 11 / 11 BIO
Clutch pedal
Brake pedal / Parking brake
Speed limiter
PRESENTATION RIDER 13/13 BIO
Parking brake
Throttle and Choke lever
Lift lever for cutting unit
Cutting unit
Rider 11 Bio and Rider 13 Bio have a twin-blade
Lifting of the cutting unit transport position
Seat
Lever for adjustment of cutting height
Fuelling
Rider
Before starting
DRIVING
Starting the engine
Rider
Warm engine
Cold engine
DRIVING
5. Set the throttle control midway between position 1 and
2. For Rider 13 and Rider 13 Bio
Driving the machine
For Rider 11 and Rider 11 Bio
The clutch must be used for each gear change
Mowing pattern
Cutting tips
DRIVING
IMPORTANT INFORMATION
Stopping the engine
Hill start, manual gearbox
Release lever Rider 13 and Rider 13 Bio
DRIVING
Maintenance schedule
MAINTENANCE
Maintenance interval
Maintenance
Engine hood
Dismantling of the machine hoods
Front hood Rider 11 and Rider
Front hood Rider 11 Bio and Rider 13 Bio
Left-hand fender
Right-hand fender
MAINTENANCE
Release the screws in the fender and lift off the fender
MAINTENANCE
Checking and adjustment of the steering wires
Check and adjust the brakes on Rider 13 and Rider 13 Bio
Adjusting the brake Rider 11 and Rider 11 Bio
Poorly adjusted brakes can result in reduced braking power
Checking the brake Rider 11 and Rider 11 Bio
MAINTENANCE
Checking and adjustment of the throttle wire
Replacement of the fuel filter
Replacing the air filter
Do not use compressed air to clean the paper filter
MAINTENANCE
IMPORTANT INFORMATION
Procedures on contact with acid
Check the level of the battery acid
Checking of the fuel pump’s air filter
MAINTENANCE
MAINTENANCE
Inspecting the safety system
Rider Rider
Check the engine’s cooling air intake
Checking the tyre pressure
MAINTENANCE
IMPORTANT INFORMATION
MAINTENANCE
Checking the cutting unit’s parallelism
30 - English
MAINTENANCE
Placing in service position
MAINTENANCE RIDER 11 BIO/13 BIO
Service position for BioClip
5. Disengage the spring from the drive belt tensioning wheel
MAINTENANCE RIDER 11 BIO/13 BIO
MAINTENANCE RIDER 11 BIO/13 BIO
Restoring from service position
Replacing the break-pin BioClip
Checking the blades
Cutting unit rear ejection Bio
MAINTENANCE
Check the engine’s oil level
LUBRICATION
Changing the oil
IMPORTANT INFORMATION
Lubrication of belt tensioner
Check the transmission’s oil level Rider 13 and Rider 13 Bio
General lubrication
LUBRICATION
Lubrication of front wheel bearings
Lubrication Rider 11 and Rider 11 Bio
Check that the lock-ring is correctly posi- tioned in the slot
LUBRICATION
Procedure
TROUBLE SHOOTING SCHEDULE
Problem
Winter storage
Service
STORAGE
Dimensions
TECHNICAL DATA
Rider
Electrical system
Rider 13 Bio
Rider 11 Bio
TECHNICAL DATA
Dimensions
Directive 89/392/EEC, Annex II, A
EU declaration of conformity Only applies to Europe
Pre-delivery service
SERVICEJOURNAL RIDER 11/13
Work done
Date, mileage, stamp, sign
´*3/r¶69¨
SERVICEJOURNAL
Work done
Date, mileage, stamp, sign
Page
´*3/r¶69¨
2000W50