Manuals / Husqvarna / Household Appliance / Sewing Machine

Husqvarna 850 Lift lever for cutting unit, Lever for adjustment of cutting height, Epresentation

Models: 970

1 36

Download 36 pages 63.29 Kb

Page 14

Image 14

EPRESENTATION

Lift lever for cutting unit

The lift lever is used to set the cutting unit in trans- port or cutting position.

If the lever is pulled back the unit will lift up and the blades stop rotating (transport position).

If the lock button is pressed and the lever is moved forward the unit will lower down and the blades begin rotating (cutting position).

The lever can also be used to temporarily regulate the cutting height, e.g. for a small mound in the lawn.

Lifting of the cutting unit (transport position)

Lowering of the cutting unit (cutting position)

Lever for adjustment of cutting height

With this lever the cutting height can be adjusted to 9 different positions (40–90 mm, 45–80 mm Bioclip).

12 – English

Page 14

Image 14

Husqvarna 850, 970 manual Lift lever for cutting unit, Lever for adjustment of cutting height, Epresentation

Contents

Operator´s manual 101Rider 850/970 R I D E RPage CONTENTSE Operator’s Manual for Rider 850 Rider I. General operation SAFETY INSTRUCTIONSSafe operation practices for ride-on mowers II. Slope operationPart Package IV. ServiceWheel assembly USA Danger, keep hands and feet awayEXPLANATION OF SYMBOLS Clear the area from stones etc. before cutting General useRead the instructions before starting the machine Never carry passengersCut slopes upwards and downwards, not sideways Be extra careful when driving on slopesDriving on slopes SAFETY INSTRUCTIONSKeep children away from the mowing area MaintenanceChildren Never allow children to drive the machineNever drive the machine in an enclosed space Never smoke in the vicinity of the battery or the fuelClean the machine regularly from grass, leaves and other waste SAFETY INSTRUCTIONSLocation of the controls PRESENTATIONEPresentation Clutch pedal EPRESENTATIONThrottle and Choke lever Brake pedalCutting unit Parking brakeGear shift PRESENTATIONELifting of the cutting unit transport position Lever for adjustment of cutting heightLift lever for cutting unit Lowering of the cutting unit cutting positionFuelling PRESENTATIONSeat Starting the engine DRIVINGBefore starting DRIVING 4. Push the throttle control to position 3 chokeDriving the machine DRIVINGDRIVING Cutting tipsMowing pattern DRIVING Starting on slopesStopping the engine MAINTENANCEE Maintenance scheduleEMAINTENANCE Dismantling of the machine hoodsCheck the engine’s cooling air intake MAINTENANCECheck the engine’s oil level Checking of the fuel pump’s air filterChecking and adjustment of the steering wires EMAINTENANCECheck the safety system Adjusting the brakeCheck the level of the battery acid Checking the brakeReplacing the air filter EMAINTENANCEChecking the cutting unit’s parallelism Checking and adjustment of the cuttingunit’s ground pressure Rider MAINTENANCE26 - English Adjustment of the cutting unit’s parallelismEMAINTENANCE Dismantling the cutting unit MAINTENANCECutting unit on Rider 850 rear ejection Checking the bladesChecking the tyre pressure EMAINTENANCE4. Fit the drain plug and tighten Changing the oilLubrication MAINTENANCEEMAINTENANCE Checking and adjustment of the throttle wireReplacement of the fuel filter 30 - EnglishProcedure TROUBLE SHOOTING SCHEDULEProblem ESTORAGE Service«*2T6B¬ Winter storageTECHNICAL DATA «*2T6B¬