SAFETY INSTRUCTIONS | E |
IV. Service
1.Use extra care in handling gasoline and other fuels. They are flammable and vapours are explosive.
a)Use only an approved container.
b)Never remove gas cap or add fuel with the engine running. Allow engine to cool before refuelling. Do not smoke.
c)Never refuel the machine indoors.
d)Never store the machine or fuel container inside where there is an open flame, such as in a water heater.
2.Never run a machine inside a closed area.
3.Keep nuts and bolts, especially blade attach- ment bolts, tight and keep equipment in good condition.
4.Never tamper with safety devices. Check their proper operation regularly.
5.Keep machine free of grass, leaves or other debris
6.Stop and inspect the equipment if you strike an object. Repair, if necessary, before restarting.
7.Never make adjustments or repairs with the engine running.
8.Grass catcher components are subject to wear, damage and deterioration, which could expose moving parts or allow objects to be thrown.
Frequently check components and replace with manufacturer’s recommended parts, when necessary.
9.Mower blades are sharp and can cut. Wrap the blade(s) or wear gloves and use extra caution when servicing them.
10.Check brake operation frequently. Adjust and service as required.
Danger, keep hands and feet away
Wheel assembly (USA)
To remove tractor from carton:
Remove cardboard outer container from pallet.
-check for any additional loose parts.
-lift seat from unit
-remove parts bag and steering wheel
-check contents of bag and with inventory list
-remove tire and wheel assemblies from pallet
-remove covers from retaining blocks on axles
-install steering wheel
-loosen set screw
-place column over shaft and seat against washer
-center the wheel
-tighten the set screw – seat in slot on shaft
-secure set screw with jam nut
-fasten hitch plate to rear bumper with 2 bolts
-raise and support the rear of the unit
-install drive wheels and parts
-large washer
-spacer
-wheel and key
-small washer
-“E” clip – seat in groove in axles
-lower the unit
-raise and support the front of the unit
-install front wheels
-small washer
-snap ring – seat in groove in axles
-lower the unit
-remove the unit from the shipping pallet by rolling forward to avoid damage to the under- carriage
-install the chute deflector
-remove front cowling – 3 screws
-insert pin into bracket and shoulder bolt in hole – nut towards rear
-install spring – hole on chute to bolt near pulley
-check belts and pulleys
-install cowling
Part Package
4 hubcaps
1chute deflector
1B & S manual
6battery caps
2ignition keys
2square keys – drive wheels
2“E” clips – drive wheels
2 spacers
2large washers – drive wheels
2small washers – drive wheels
1spring – deflector
1shoulder bolt and nut – deflector
1hitch bracket
2 | bolts |
2 | washers – front wheels |
2outside snap rings – front wheels
1pkg battery bolts and nuts
English – 3
