Manuals / Husqvarna / Household Appliance / Sewing Machine

Husqvarna 850, 970 manual Checking and adjustment of the steering wires, Emaintenance

Models: 970

1 36

Download 36 pages 63.29 Kb

Page 24

Image 24

EMAINTENANCE

Checking and adjustment of the steering wires

The steering is controlled by means of wires.

These can in time become slack, which implies that the adjustment of the steering becomes altered.

Check and adjust the steering as follows:

1. Dismantle the frame-plate by releasing the screws (two on each side).

2. Check the tension of the steering wires by pushing them together as shown in the diagram. It should be possible to push them together so that the distance between them is half as much, without using unnecessary force.

3.When necessary the wires can be tensioned by tightening the adjusting nuts, one on each side

of the steering rim.

Do not tension the wires too tightly, they should only be tightened up to the steering rim.

Check the wire tension on completion of the adjustment as per item 2.

22 – English

Page 24

Image 24

Husqvarna 850, 970 manual Checking and adjustment of the steering wires, Emaintenance

Contents

101 Rider 850/970Operator´s manual R I D E RPage CONTENTSE Operator’s Manual for Rider 850 Rider SAFETY INSTRUCTIONS Safe operation practices for ride-on mowersI. General operation II. Slope operationIV. Service Wheel assembly USAPart Package Danger, keep hands and feet awayEXPLANATION OF SYMBOLS General use Read the instructions before starting the machineClear the area from stones etc. before cutting Never carry passengersBe extra careful when driving on slopes Driving on slopesCut slopes upwards and downwards, not sideways SAFETY INSTRUCTIONSMaintenance ChildrenKeep children away from the mowing area Never allow children to drive the machineNever smoke in the vicinity of the battery or the fuel Clean the machine regularly from grass, leaves and other wasteNever drive the machine in an enclosed space SAFETY INSTRUCTIONSPRESENTATIONE PresentationLocation of the controls EPRESENTATION Throttle and Choke leverClutch pedal Brake pedalParking brake Gear shiftCutting unit PRESENTATIONELever for adjustment of cutting height Lift lever for cutting unitLifting of the cutting unit transport position Lowering of the cutting unit cutting positionPRESENTATION SeatFuelling DRIVING Before startingStarting the engine DRIVING 4. Push the throttle control to position 3 chokeDriving the machine DRIVINGCutting tips Mowing patternDRIVING Starting on slopes Stopping the engineDRIVING MAINTENANCEE Maintenance scheduleEMAINTENANCE Dismantling of the machine hoodsMAINTENANCE Check the engine’s oil levelCheck the engine’s cooling air intake Checking of the fuel pump’s air filterChecking and adjustment of the steering wires EMAINTENANCEAdjusting the brake Check the level of the battery acidCheck the safety system Checking the brakeReplacing the air filter EMAINTENANCEChecking and adjustment of the cutting unit’s ground pressure RiderChecking the cutting unit’s parallelism MAINTENANCEAdjustment of the cutting unit’s parallelism EMAINTENANCE26 - English Dismantling the cutting unit MAINTENANCEChecking the blades Checking the tyre pressureCutting unit on Rider 850 rear ejection EMAINTENANCEChanging the oil Lubrication4. Fit the drain plug and tighten MAINTENANCEChecking and adjustment of the throttle wire Replacement of the fuel filterEMAINTENANCE 30 - EnglishTROUBLE SHOOTING SCHEDULE ProblemProcedure Service «*2T6B¬ESTORAGE Winter storageTECHNICAL DATA «*2T6B¬