12 | Installation of Wiring for Wired |
| |
| Infrared Safety Sensor |
|
|
Tools Needed: | Uncoil the wires from the infrared safety |
| sensors and route the wire up the garage |
Hammer | wall across the ceiling and down to the back |
| of the opener. Tack the wires in place using |
| staples (Not Supplied). Take care to run |
| the wires in a location where they will not |
| interfere with the operation of the door and |
| do not staple through wire. |
| NOTE: If wires must be lengthened or |
| spliced into pre wired installation, use wire |
| nuts or other suitable connectors. |
Wire to Opener
13 | Connecting Wired Infrared Safety |
| |
| Sensor to Opener |
|
|
Tools Needed: | Connect infrared safety sensors to the |
| opener as shown. Shorten wires as |
Phillips Head | necessary and separate wire ends. Strip |
Screwdriver | about 1/2” of insulation off each wire, being |
| careful not to nick wires, and attach wires |
| to the proper terminal screws, then tighten |
| securely, using phillips head screwdriver. |
| One wire has marking on it (numbers, black |
| stripe, etc). Be sure to observe polarity. Apply |
| tension to external wires to test for secure |
| connection. Check that the wires are stapled |
| in place properly. |
|
|
Right Side Of Opener
Sending Unit |
| Black Strip | Receiving Unit |
|
|
| |
| OBS |
|
|
| COM |
|
|
| P.B. | Solid | LED |
|
| ||
|
|
| |
|
| Color |
|
10Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need
You can reach us Toll Free at
