Table of Contents
Package Contents | I. |
II, III | |
Tools Needed | IV. |
Important Safety Instructions | V. |
Prodrive ® Installation | |
Optional Installations | |
Operation | |
Programing Wireless Wall Station Or Transmitter(s) to Opener | 33. |
Maintenance | 34. |
Troubleshooting | 35. |
Parts Breakdown Rail Assembly | 36. |
Parts Breakdown Opener Assembly | 37. |
Accessories | 38. |
Templates | 39. |
Customer Service Number | 40. |
Warranty | 41. |
Definition of key words used in this manual:
WARNING
INDICATES A POTENTIALLY HAZARDOUS SITUATION WHICH, IF NOT AVOIDED, COULD RESULT IN SEVERE OR FATAL INJURY.
CAUTION: PROPERTY DAMAGE OR INJURY CAN RESULT FROM FAILURE TO FOLLOW INSTRUCTIONS.
IMPORTANT: REQUIRED STEP FOR SAFE AND PROPER OPENER OPERATION.
NOTE: Information assuring proper installation of the opener.
WARNING
INCORRECT INSTALLATION CAN LEAD TO SEVERE OR FATAL INJURY. FOLLOW THESE INSTRUCTIONS CAREFULLY.
IMPORTANT INSTALLATION
INSTRUCTIONS
1.READ AND FOLLOW ALL INSTALLATION INSTRUCTIONS.
2.Do not connect the opener to electrical power until instructed to do so.
3.Install the entrapment warning label next to the wall station in a prominent location. Install the emergency disconnect label on the emergency disconnect cord.
4.Remove all ropes and remove, or make inoperative in the unlocked position, all locks connected to the garage door before installing the opener.
5.Do not wear rings, watches or loose clothing when installing or servicing a garage door system.
6.It is important that you install all the components supplied with the Prodrive ® opener, i.e., wall stations, safety sensors, etc. Use of parts not supplied by
7.Wear protective eye wear when installing or servicing the opener or door.
8.Install opener on a properly balanced and operating garage door. Have a qualified service person make adjustments/repairs to cables, spring assemblies, and other hardware before installing the opener. An improperly balanced door could cause severe or fatal injury.
9.Where possible, install the opener seven feet or more above the floor. Mount the emergency disconnect six feet above the floor.
10.Locate the wall station: (a) within sight of door, (b) at a minimum height of five feet, so small children cannot reach it, and (c) away from all moving parts of the door.
11.After installing the opener, the door must reverse when it contacts a
12.Installation and wiring must comply with local building and electrical codes. Connect the power cord to a properly grounded outlet. Do not remove the ground pin from power cord.
13.To reduce the risk of injury to persons, use this opener only with sectional overhead doors.
14.Top section of garage door may need to be reinforced before attaching opener. Check with your garage door manufacturer for their recommendations.
15.Do not use sensitivity adjustments to compensate for a poorly operating door. This will prevent proper operation of the safety reverse feature and may damage the door and cause possible severe or fatal injury.
16.An open door must not close and closing door must reverse and open if infrared safety sensors are obstructed by 6” high object placed on garage fl oor.
17.Use a sturdy,
AFTER INSTALLATION IS COMPLETE, FASTEN THIS MANUAL NEAR GARAGE DOOR. PERFORM OBSTRUCTION TESTS MONTHLY AND MAINTENANCE AS RECOMMENDED. SEE PAGES 17 & 34.
VPlease Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need
You can reach us Toll Free at
