19 | Setting Door Close Travel |
| |
|
|
Tools Needed: | Using the wall control up/down button, |
| activate door to full open position; |
Flat Tip | reactivate to close position. |
Screwdriver |
|
| The door should stop on the floor with the |
| bottom door seal slightly compressed. |
| If the door reverses off the floor, turn close |
| travel knob 1/4 turn “less”. |
| If door is not completely closed, turn travel |
| knob 1/4 turn “more”. |
| Repeat as necessary. |
| NOTE: 1/4 turn equals 1” of door travel. |
|
|
Bottom Of Opener
TRAVEL ADJUSTMENT
OPENCLOSE
LESS
MOREMORE
20 | Setting Door Opening Travel |
Tools Needed: | The door opener is assembled with the open |
| travel adjustment preset for a typical door, |
Flat Tip | but all doors should be adjusted to stop as |
Screwdriver | close as possible to the door’s “natural” fully |
| open, resting position. |
| To determine the door’s “natural” fully open, |
| resting position, disconnect door from |
| opener using the emergency release |
| disconnect (see page 27, EMERGENCY |
| DISCONNECT) and manually raise door to its |
| “natural” fully open, resting position. Use this |
| location for your open limit setting. To |
| determine if door needs adjustment, activate |
| the opener to bring door to fully open |
| position. |
|
|
Bottom Of Opener
TRAVEL ADJUSTMENT
OPENCLOSE
LESS
MOREMORE
Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need 15 You can reach us Toll Free at
