24 | Installing Wireless Keyless Entry |
| |
| (If Included) |
| IMPORTANT: INSTALL ALL WALL |
Tools Needed: | |
| CONTROLS OUT OF THE REACH OF |
Power Drill | CHILDREN AND IN A LOCATION WHERE THE |
| DOOR CAN BE SEEN BEFORE ACTIVATING. |
5/64” Drill Bit | Locate a convenient place to mount the |
| |
Phillips Head | wireless keyless entry, that does not |
Screwdriver | interfere with the normal opening and |
| closing of the door. To keep keyless entry |
| out of the reach of children, measure and |
| mark a spot at least 5 feet up from the floor. |
| Use the drilling template located on Page 39 |
| to determine hole positions. Drill 5/64” pilot |
| holes 3/4” deep at each screw location. |
| Snap open the wireless keyless entry case |
| with a coin. Secure keyless entry base into |
| wood framing using the two screws |
| provided. Snap the front case half back onto |
| the base. Remove paper backing from |
| instruction label and apply to a clean |
| surface inside garage. |
| NOTE: Two screws are included for |
| mounting to wood structures. Ensure proper |
| hardware is used for mounting to other |
| materials. |
| NOTE: After completing this step, continue |
| with page 27. |
|
|
Keyless Entry |
5’ |
Keyless Entry Base |
Keyless Entry Front |
Case |
Screws |
Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need 19 You can reach us Toll Free at
