EMAINTENANCE
Adjustment of the cutting unit’s parallelism
Adjustment of Rider 850
1. Dismantle the front hood and
2. Vertical adjustment of the cutting unit is made with the adjusting nuts on the back edge of the
3. Raise the cutting unit at the front edge by shortening the
Lower the cutting unit at the front edge by lengthening the
4.Tighten the nuts against each other after the adjustment.
5.On completion of the adjustment the unit’s parallelism should be
Fit the
Adjustment of Rider 970
1.Dismantle the front hood and
2.Release the strut by pulling out the rear pin (1). Lift the rear edge of the hood to relieve the parallel strut.
3.Release the
4.Screw out the fork (3) to raise the front edge of the hood.
Screw in the fork (3) to lower the rear edge of the hood.
5.Tighten the
6.On completion of the adjustment the unit’s parallelism should be
Fit the
1 | 3 | 2 |