OPERATION
CONNECTION V220/230 - 50 Hz
ATTENTION MOTOR PROTECTOR
A motor cut
For
VERSION Manual lawn mower
Before connecting up the lawn mower to the electric power supply, make sure that the mains supply voltage is 220- 230V/50Hz and that a ground fault interrupter is installed on the mains circuit. Start the mower as follows:
a)Press the safety
b)Start the mower by pulling the lever (11) towards the handle and keeping it pressed down. If you release the lever, the motor will stop.
CAUTION! The blade starts turning as soon as the mower is started.
VERSION Self-Propelled
Before connecting up the lawn mower to the electric power supply, make sure that the mains supply voltage is 220- 230V/50Hz and that a ground fault interrupter is installed on the mains circuit. Start the mower as follows:
a)Press the safety
b)Start the mower by pulling the lever (11) towards the handle and keeping it pressed down. If you release the lever, the motor will stop.
CAUTION! The blade starts turning as soon as the mower is started.
MOWING
To cut the grass, push the lawn mower manually or insert the automatic advance gear.
How to insert automatic advance: Lift up the clutch lever (13) and keep it pressed in position.
How to disengage advance: Release the clutch lever.
MOWING
To cut the grass, push the lawn mower manually
ADJUSTMENT OF CLUTCH CABLE (for self-propelled versions only)
Important: If, when you press the clutch lever, the automatic advance gear does not engage, the clutch cable should be adjusted by inserting the spring (P) in one of the subsequent holes (S) in the clutch lever (13).
AUTOMATIC ADVANCEMENT (for self-propelled versions only)
|
| Periodically check the automatic advance assem- | To carry out this check, you must remove the wheel (17) by |
|
| bly and make sure to keep it clean. In particular, | unscrewing the screw (18). Before reinstalling the wheel, |
|
| ||
|
| the pinion (15) and the gear (16) must be kept | put grease on the pinion and gear. |
perfectly clean. |
| ||
MAINTENANCE
Before carrying out any operations on the cutting tool, stop engine
Frequently check the mower and ensure that all grass deposits are removed from beneath the deck.
Never clean the mower by pouring water over it: this may seriously damage the electrical system.
Frequently remove the wheel screws clean whith pe- troleum and oil before replacing. Ball bearings must be greased before remounting.
Frequently check the blade for damage.
The lawn mower must be checked by a SERVICE
DEALER.
ENGLISH - 4
