PRESENTATION
Adjusting the cutting height
The cutting height can be adjusted to seven different positions.
Select the required cutting height
Lever for hydraulic lift of attachments
The lifting lever is used to put the cutting unit in either the transport or mowing position when hydraulic pressure is available.
The lever has four different positions.
•Position 1 is the neutral position.
•Position 2 lowers the cutting unit with spring return to the neutral position
•Position 3 is floating where the lever stops. The unit is lowered to the automatically floating position, which means that the cutting unit follows the contours of the ground.
•Position 4 raises the cutting unit with spring return to neutral position.
When cutting the lever should be set directly to the floating position (3).
Lifting the Cutting Unit (Transport Position)
Stop the blades by pressing the stop button.
Pull the lever backwards to engage the transport position.The unit is then raised.
The cutting unit can be raised slightly with the blades rotating. This is to facilitate the mowing of extremely tall grass or uneven surfaces.
Lowering the Unit (Mowing Position)
Move the hydraulic lifting lever forwards to engage the cutting position.
When cutting the lever should be set directly to the floating position (3).
Controls for operating the cutting unit blades
The cutting unit can be started only when the driver is sitting in the seat.
•Pull out the lever to engage the drive of the blades.
•Push in the lever to disengage the blades.
When the safety circuit has stopped the drive to the cutting unit, the control must be pushed and pulled out again to start the blades.
The safety circuit is triggered and the cutting unit is stopped in the following cases:
•When the driver leaves the seat with the blades engaged. There is a short delay to prevent stopping if the driver bounces on the seat.
English – 13
