Storage
Winter storage
At the end of the season, or if the machine is going to stand idle for more than 30 days, it should immediately be made ready for storage. Fuel which is left to stand for long periods (30 days or more) can leave sticky deposits and interfere with the engine function.
Fuel stabiliser is an acceptable alternative to avoid tacky deposits during storage. Add stabiliser to the fuel in the tank or the storage container. Always use the mixing ratios indicated by the manufacturer. Run the engine for at least 10 minutes after adding the stabiliser.
WARNING! Never store a machine with fuel
!in the tank indoors or in poorly ventilated spaces where fuel vapour can come in contact with open flames, sparks, or a pilot light such as in a boiler, hot water tank, clothes drier, etc. Exercise caution when handling fuel. It is highly inflammable, and careless use can cause serious injury and damage to property. Drain off the fuel in an approved container outdoors and well clear of naked flames. Never use petrol for cleaning purposes. Use degreasing agents and hot water instead.
To prepare the machine for storage follow these instructions:
1Carefully clean the machine, especially under the cutting unit.
2Inspect the machine for worn or damaged parts and tighten loose screws and nuts.
3Change the engine oil, and take care of the waste oil.
4Fill fuel tank.
5Grease all grease nipples, joints and axles.
6Remove the battery. Clean it, charge it, and store it in a cool place.
7Store the machine in a clean and dry place and cover it over for extra protection.
Guard
There is a cover to protect your machine during storage or transport. Contact your dealer for a demonstration
Service
Low season is the most suitable time to perform a service or overhaul of the machine in order to ensure high function safety during high season.
When ordering spare parts state your machine’s purchase year, model, type, and serial number.
Always use genuine parts.
An annual
English – 53
