Service journal
Pre-delivery service
1 Top up battery with acid and charge for four hours.
2 Fit the venting hose on the battery.
3Fit steering wheel, seat and any optional equipment.
4Adjust cutting unit:
Adjust lift springs (effective weight of cutting unit should be
Adjust cutting unit so that rear edge is about
Adjust cutting unit height setting so that cutting height limit is 5 mm / 3/16” above the frame of the unit at the lowest cutting height.
5 Check that the right amount of oil is in the engine.
6 Check that there is oil in the transmission’s oil tank.
7 Check and adjust tyre pressure (60 Kpa, 0.6 bar).
8 Connect battery.
9 Fill with fuel and start engine.
10Check that machine does not move in neutral.
11Check:
Forward drive.
Reverse drive.
Operation of blades.
Seat safety switch.
Lif lever safety switch.
The safety switch for the hydrostat pedals.
12Bleed the hydraulic system of excess air, top up with oil if necessary.
13Check engine speed, 2900±100 rpm.
14Tell customer about:
Needs and benefits of following the service schedule.
Servicing and the influence of this journal on the
Range of applications for BioClip.
Complete proof of sale etc.
Date, mileage, stamp, signature
After the first 8 hours
1 Change engine oil
English – 3
