Lubrication
Hydraulic oil filter change
•Turn the old oil filter
•Lightly lubricate the rubber seal on the new oil filter using new oil.
•Tighten the filter by hand until you feel it make contact, then tighten a further 3/4 turn. Remove the transmission cover and fill the transmission’s oil tank, about 0.3 l oil. Be observant when running the engine as described below and fill so that the tank is not emptied.
Run the engine warm, manipulate the servo steering, and then check that there are no leaks around the oil filter seal.
•Check the oil level in the transmission, top up if necessary. The oil filter holds 0.3 litres of oil.
•Replace the transmission cover.
Parking brake cable PR 17 and PF 21
•Remove the transmission cover.
•Unhook the spring (A) from the screw (B).
A
B
•Remove the cable’s rubber casing when lubricating.
•Lubricate the cable with an oilcan, press the brake pedal a few times and lubricate again.
•Refit the spring (A) and the transmission cover.
Parking brake cable PR 17 AWD and PF 21 AWD
•Remove the frame plate by loosening the two screws.
•Remove the
•Lubricate both ends of the cable.
•Remove the cable’s rubber casing when lubricating.
•Lubricate the cable with an oilcan, press the parking brake pedal a few times and lubricate again.
•Refit the frame plate and wing cover.
Checking the transmission oil level
•Remove the transmission cover. Undo the two screws (one on each side) and lift off the transmission cover.
•Check that there is oil in the transmission’s oil tank.
PR 17, PF 21. Fill if necessary with engine oil SAE 10W/40 (class
PR 17 AWD, PF 21 AWD. Fill if necessary with engine oil SAE 10W/50 (class
•Replace the transmission cover.
The oil and filter should be changed by an authorised service representative, as described in the Workshop Manual. Work on the system entails particular demands on cleanliness and the system must be vented before the machine is used.
42 – English
