Maintenance
Replacing the front belt
The entire belt is removed according to the following when a snow blade is to be attached to the machine.
1Put the unit in the service position, see Service position for the cutting unit.
2Pull the centre belt off of the centre pulley. The belt becomes slack when the cutting unit is lifted.
3Take off the front belt from the centre pulley and remove the belt.
Assembly
1Fit the front belt on the centre pulley. Pull it on the outside of the runner wheel and on the inside of the idler pulley.
2PF 21 and PF 21 AWD
If PF 21 or PF 21 AWD is to be used with an accessory or with the cutting unit CombiTurf 112, the belt should be pulled on the outside of the outer runner wheel, otherwise the belt will be too long.
3Fit the centre belt on the centre pulley.
4Reset the cutting unit from service position to mowing position.
Fitting the cutting head
WARNING! Wear protective glasses when
!fitting the cutting unit. The spring which tensions up the belt may break and cause personal injury.
1Place the machine on a flat surface and apply the parking brake. Check that the lever for setting the cutting height is in the lowest position.
2Push the equipment frame down and place the catch against the frame.
3 Remove the drive belt and place it in the belt holder.
4Push the unit in and put the guide plugs in the grooves on the equipment frame, one on each side.
WARNING! Observe caution to avoid
!trapping your hand.
5Push the unit in so that the interior plugs touch the bottom of the equipment frame’s grooves.
6Lift up the cutting unit
34 – English