SMC 50 SMC 50 E SMC 50 EF, English | Husqvarna instruction

Operator´s manual

SMC 50 SMC 50 E SMC 50 EF

Please read these instructions carefully and make sure you understand them before using the one-man sawmill.

English

Page 1

Image 1

Husqvarna manual SMC 50 SMC 50 E SMC 50 EF, English

Contents

English SMC 50 SMC 50 E SMC 50 EF Table of Contents Introduction Introduction Symbols KEY to Symbols Safety Regulations Safety RegulationsPersonal Protective Equipment Fuel Safety One-man Sawmill Safety EquipmentSafety During Use Risk Zone One-man sawmill chain saw engine Description One-man Sawmill Electric Motor One-man sawmill with electric motor and feed Saw carriage FIG Height Setting FIGFrame and FIG Handlebars FIG Vibration damping plate for the chain saw FIG Chain oil tank FIGBar and chain FIG Feed unit for chain sawmill with electric motor FIG Chain saw engine FIG MotorsElectric Motor FIG Electric motor feed unit FIG Rails Height Adjustment BLog Bolsters a Folding Stops C Rail Stop Adjustable Support FeetRail Guard Safety Devices Installation InstallationInstallation Site Unpacking Saw Carriage Adjustment FIG Setting up the Saw Carriage FIG Install the bar FIG Install chain saw and bar FIGOne-man sawmill with chain saw engine One-man sawmill with electric motor Install the handlebar FIG Install scale pointer and scale FIGInstall throttle and cable FIG Checking the bar Adjusting the bar Fuel chain saw engine Fuel HandlingPetrol Mixing Two-stroke oilFuelling Starting a cold chain saw engine FIG Starting and StoppingStopping the chain saw engine FIG Starting the electric sawmill with feed FIG Starting the electric sawmill FIG Securing the Log USE Sawing Calculating the Yield Starting the Electric Motor Starting the Petrol Engine Edging FIG Clutch drum Maintenance Saw chain Drive belt Saw unit’s height adjustment Daily maintenance MaintenanceWeekly maintenance Monthly maintenance Technical data Technical Data Vibration Levels Noise LevelsEU Declaration of Conformity only applies to Europe Page 2004W12 114 02