Safety Regulations | Husqvarna SMC 50 EF manual

SAFETY REGULATIONS

Safety Regulations

!WARNING!

A one-man sawmill can be a dangerous tool that can cause serious or fatal injury if used incorrectly or carelessly. It is very important that the person using the one-man bandsaw reads and understands the content of this manual.

Personal Protective Equipment

The person or persons using the one-man sawmill or remaining in its close proximity must be equipped with the personal equipment as set out below:

1.Hearing protection.

2.Eye protection.

3.Approved protective gloves.

4.Boots or work shoes with steel toecaps and non- slip soles.

5.First aid kit.

!WARNING!

Always ensure good ventilation. Exhaust fumes and sawdust can cause injury or allergies.

English – 5

Image 5

Husqvarna SMC 50 EF manual Safety Regulations, Personal Protective Equipment

Contents

English SMC 50 SMC 50 E SMC 50 EF Table of Contents Introduction Introduction Symbols KEY to Symbols Personal Protective Equipment Safety RegulationsSafety Regulations Fuel Safety One-man Sawmill Safety EquipmentSafety During Use Risk Zone One-man sawmill chain saw engine Description One-man Sawmill Electric Motor One-man sawmill with electric motor and feed Saw carriage FIG Height Setting FIGFrame and FIG Handlebars FIG Vibration damping plate for the chain saw FIG Chain oil tank FIGBar and chain FIG Feed unit for chain sawmill with electric motor FIG Chain saw engine FIG MotorsElectric Motor FIG Electric motor feed unit FIG Rails Height Adjustment BLog Bolsters a Folding Stops C Rail Guard Adjustable Support FeetRail Stop Safety Devices Installation InstallationInstallation Site Unpacking Saw Carriage Adjustment FIG Setting up the Saw Carriage FIG Install the bar FIG Install chain saw and bar FIGOne-man sawmill with chain saw engine One-man sawmill with electric motor Install throttle and cable FIG Install scale pointer and scale FIGInstall the handlebar FIG Checking the bar Adjusting the bar Petrol Fuel HandlingFuel chain saw engine Fuelling Two-stroke oilMixing Stopping the chain saw engine FIG Starting and StoppingStarting a cold chain saw engine FIG Starting the electric sawmill with feed FIG Starting the electric sawmill FIG Securing the Log USE Sawing Calculating the Yield Starting the Electric Motor Starting the Petrol Engine Edging FIG Clutch drum Maintenance Saw chain Drive belt Saw unit’s height adjustment Daily maintenance MaintenanceWeekly maintenance Monthly maintenance Technical data Technical Data EU Declaration of Conformity only applies to Europe Noise LevelsVibration Levels Page 2004W12 114 02